When building roads, is there a way to direct traffic in a different manner? I’ve tried deleting the right lane of a road so the UI will use the closest road but the UI uses the left lane and goes into the stop.
Also, I’ve seen jets fly off the runway and onto the grass then turnaround.
Welcome to the forums Cengro.
Not at this time, no. 1 way roads aren’t supported yet , so your milage may vary 
Did you see the jet issue when you sped up the game?
Do make bug reports of this, with as much information as possible and a save of you can
Here is one instance of the problem and yes F10 does not clear the issue.
The bus are going around and around in a circle and the teal car is stuck not moving
Yes the planes flying off the runway happen when game is in fast forward mode.
I can also confirm that planes run off the runway when speed is set to max.
My solution was to extend the runway, but obviously that should not be neccessery.
Same, planes are outside the runway a lot.
I also have a plane stuck, can we pls make all taxi traffic lanes 1 direction if we want to.
What is his status if you click on the aircraft?
Jasper that is NOT how you use holding points
Aha, then why are there holding points?
It has a “no free stand” warning.
And you have a free medium stand?
Nope, let me reparse that, 2 of 2 are full, but it was stuck for a while already if I remember correctly. All planes that taxi now I booted the game, just pass through this plane as if it is not there. So even when a medium stand frees up, it stays put.
I was already busy in a new level. Thought up a new setup.
You put them before the runway mostly
Can you give an example, can flight stands get a number btw, so that if an error pops up about a full plain stand, I can look at that # plane stand?
You can rename stands. I go with A1, A2 etc and if 2nd concourse B1, B2 etc.
This topic was automatically closed 31 days after the last reply. New replies are no longer allowed.
