Safety area too large and staff doesn´t go to work

[Daiq]

Hello, I have the following problems. At the middle stand, which can be seen in the picture on the top left, I got the message that there is no connection to a security checkpoint. Apparently this is too far away. Is there a maximum size for security areas? As a solution I have attached a security check to the building, but this is ignored by the staff, which is reflected in the passengers jamming there.

Staff is actually more than enough, but they seem to ignore their work. Not a single check-in desk is busy, most boarding counters are also unoccupied. This only occurred when I extended the left terminal to its current size. Last I grew the two middle stands at the top of the terminal. And of course the weird security clearance.

[EG0611]

I built way bigger airports that that and I can assure you that there is no problem such as “too big”.

Could you try to take a photo of airport with areas enabled? Maybe it could be a simple area coverage issue. Also do errors disappear when you load save?

EDIT: Another suggestion: Build staff rooms in secure areas. 1 room with plenty of seatings would be enough.

[Stu]

It is your staff rooms! They cross the security zones, any enterance to secure zone needs a security check point and secure exit. At present you just have the doors in the rooms have door to both secure and non secure areas